H3C Technologies H3C S12500 Series Switches - Manual (Page 143)

127
[SwitchD] display ip routing-table 1.1.1.1 verbose
Routing Table : Public
Summary Count : 1
Destination: 1.1.1.1/32
Protocol: OSPF Process ID: 1
Preference: 10 Cost: 1
IpPrecedence: QosLcId:
NextHop: 13.13.13.1 Interface: Vlan-interface200
BkNextHop: 24.24.24.2 BkInterface: Vlan-interface101
RelyNextHop: 0.0.0.0 Neighbor : 0.0.0.0
Tunnel ID: 0x0 Label: NULL
BKTunnel ID: 0x0 BKLabel: NULL
State: Active Adv Age: 00h01m27s
Tag: 0
Configuring BFD for OSPF
Network requirements
As shown in Figure 51 , OSPF is enabled on Switch A, Switch B and Switch C that are reachable to each
other at the network layer.
After the link over which Switch A and Switch B communicate through a Layer 2 switch fails, BFD can
quickly detect the failure and notify OSPF of the failure. Then Switch A and Switch B communicate
through Switch C.
Figure 51 Network diagram
Device Interface IP address Device Interface IP address
Switch A Vlan-int10 192.168.0.102/24 Switch B Vlan-int10 192.168.0.100/24
Vlan-int11 10.1.1.102/24 Vlan-int13 13.1.1.1/24
Switch C Vlan-int11 10.1.1.100/24
Vlan-int13 13.1.1.2/24
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic OSPF:
# Configure Switch A.
system-view