Defining a continue clause – H3C Technologies H3C S12500 Series Switches User Manual
Page 427
411
Step Command
Remarks
9.
Set the next hop.
•
Set the next hop and specify the
VPN instance of the next hop for
IPv4 routes:
apply ip-address next-hop
ip-address [ vpn-instance
vpn-instance-name | public ]
•
Set the next hop for IPv6 routes:
apply ipv6 next-hop
ipv6-address
Optional.
Not set by default.
The apply ip-address next-hop
and apply ipv6 next-hop
commands do not apply to
redistributed IPv4 and IPv6
routes.
10.
Inject routing information to a
specified ISIS level.
apply isis { level-1 | level-1-2 |
level-2 }
Optional.
Not configured by default.
11.
Set the local preference for
BGP routing information.
apply local-preference preference
Optional.
Not set by default.
12.
Set MPLS label.
apply mpls-label
Optional.
Not set by default.
13.
Set the origin attribute for BGP
routing information.
apply origin { egp as-number | igp
| incomplete }
Optional.
Not set by default.
14.
Set the preference for the
routing protocol.
apply preference preference
Optional.
Not set by default.
15.
Set a preferred value for BGP
routing information.
apply preferred-value
preferred-value
Optional.
Not set by default.
16.
Set a tag value for RIP, OSPF or
IS-IS routing information.
apply tag value
Optional.
Not set by default.
17.
Configure FRR.
apply fast-reroute
{ backup-interface interface-type
interface-number [ backup-nexthop
ip-address ] | backup-nexthop
ip-address }
Optional.
Not configured by default.
Defining a continue clause
Follow these guidelines when you define a continue clause:
•
If you configure the same type of apply clauses that set different values (including the apply
community and apply extcommunity clauses with the additive keyword) on nodes that are
combined by the continue clause, the apply clause configured on the last matching node takes
effect.
•
If you configure the apply community clause for multiple nodes that are combined by the continue
clause, the apply comm-list delete clause configured on the current node cannot delete the
COMMUNITY attributes of preceding nodes.
To define a continue clause:
Step Command
Remarks
1.
Enter system view.
system-view
N/A