Alinco DJ-X11 - Manual (Page 99)

12
12. Cable-clone and PC Connection Functions
99
12-2 Cable-Clone Receiving Data
Use the following procedure to copy data from another DJ-X11 or to receive
data edited on a PC.
1 Turn OFF the Slave and connect the stereo mini-plug
cable to its earphone jack.
CLONE 57600bps
2 While holding down the ［MONI］
key, press the ［ POWER ］key
to turn ON the Slave.
“CLONE” appears on the LCD and the
Slave enters Clone mode.
3 Wait until the Master DJ-X11 or PC sends data.
4 When the data transfer is complete, the DJ-X11 automat-
ically returns to VFO mode.
CAUTION
• The stereo mini-plug cable should be a direct-coupled type. (without an
internal resister)
• Do not operate any key while data is transferred by the clone function.
• Do not unplug the cable while data is being transferred. Doing so will
suspend the data transfer operation, and “ERROR” will be displayed
on the Master’s LCD. if this happens, perform the reset (P.101) to the
slave unit and retry.
• Note that the cloning procedure overwrites all data stored in the Slave
with the Master’s data. Make sure that the Slave does not have any
necessary data.