Alinco DJ-X11 - Manual (Page 76)

76
10. Set Mode Confi gurations
10
10-1-4 CW setting
Use this setting to receive unmodulated continuous waves (Morse code
signals).
145.000
F M
VFO
B S
CW
CWL
1 Rotate the upper dial to select
“CW”.
2 Rotate the lower dial to select
“CWL” or “CWU”.
Select the setting with which you can hear more easily.
10-1-5 Detected signal output function
Some digital signals, such as 9600 bps high-speed packet communication
of amateur radio, use modulation methods called FSK or GMSK. Conse-
quently, these signals cannot be received properly with the DJ-X11 which
receives fi ltered audio signals such as 1200 bps AFSK packets. In such
a case, you may be able to receive data communication by inputting the
signals to a dedicated connecting device (TNC, etc.) or a PC.
CAUTION
• The communication you want to receive may not be able to be de-
coded due to various conditions such as the compatibility of your de-
vice, software and PC, PC properties setting, and the signal receiving
environment (noise or suppression). Note that Alinco does not offer
any support other than testing “Weather or not your DJ-X11 meets
our factory-standard specifi cations.” for this reason. Also, we cannot
answer questions about the operating procedure of specifi c devices or
software, or the type or environment settings of PCs.
• The received data will be output from the data signal output terminal of
the 3-pole stereo mini-plug (P. 98).
145.000
F M
VFO
B S
DET out
Disable
1 Rotate the upper dial to select
“DET out”.
2 Rotate the lower dial to select
“Disable” or “enable”.
When "enable" is selected, the sound of the main band is not output.