Alinco DJ-X11 - Manual (Page 16)

16
3. Attaching Accessories
3
3-4-2 Removing the battery pack
(2)
(1)
1 Slide the lock lever at the
bottom of the battery pack in
the direction of arrow (1) and
remove the battery pack (2).
CAUTION
• The battery pack is not fully charged when shipped. You need to
charge it after purchase before use.
• The battery pack must be charged within the temperature range of 0 to
40°C.
• Do not modify or dismantle the battery pack and do not throw it into fi re
or water. These actions are dangerous.
• Do not short-circuit the battery pack terminals. This may damage the
equipment, or may cause burns by the heat generated from the battery.
Do not charge the battery pack for an unnecessarily long time (over-
charging). This may deteriorate battery performance.
• The battery pack should be stored in a dry place where the tempera-
ture range is between -10°C and +45°C. Storing the battery pack in
locations with high humidity or temperatures outside the proper range
may cause the battery solution to leak or the metal sections to rust.
• The battery pack is a consumable article. When the battery pack be-
comes exhausted extremely quickly even when it has been charged
for the specifi ed time, it may have reached the end of its life. In such a
case, replace the battery pack with a new one.
• The battery pack is a recyclable resource. Do not dispose the battery
pack but take it to a battery recycling center in your area. The battery
pack is dedicated for use in Alinco products. It can be charged only us-
ing the applicable genuine charger or conforming receiver. Charging
it with commercially-available or third-party chargers or adapters may
cause a breakage or accident. Clean the electrodes of the battery pack
and charger with a dry cotton swab from time to time.
• Even if you do not use the battery pack for a long time, charge it at
least once every three months to prevent deterioration.
• The supplied battery pack is dedicated for use in the DJ-X11. Charging
it with chargers or adapters other than specifi ed models may cause a
breakage or accident.