Alinco DJ-X11 - Manual (Page 15)

3. Attaching Accessories
15
3
3-3 Belt Clip
Belt clip
3-3-1 Attaching the belt clip
1 Align the belt clip with the groove
at the rear of the receiver to
secure it, insert the screw into the
hole and rotate it clockwise (to
the right).
2 Check that the belt clip is securely
attached to the receiver.
* The screw may become loose during use. Check the tightness from
time to time.
* The belt clip can be adjusted so that it can be used for a belt of
approximately 8 cm width at maximum.
3-3-2 Removing the belt clip
1 Rotate the screw counterclockwise (to the left) and
remove the belt clip.
3-4 Battery Pack
For the procedure for charging the lithium ion battery pack (EBP-74), refer to
“Charging the Battery Pack with the Charger” (P. 18) and “Charging the Battery
Pack through the DC Jack” (P. 17).
3-4-1 Attaching the battery pack
(1)
(2)
Hooks
Groove
1 Align the hooks of the battery
p a c k w i t h t h e g r o o v e s o f
the receiver and push in the
battery pack in the direction of
arrow (1).
2 Slide the lock lever at the
bottom of the battery pack in
the direction of arrow (2).