Alinco DJ-X11 - Manual (Page 88)

88
10. Set Mode Confi gurations
10
10-4-11 Remote COM port setting
The ERW-8 is an optional cable like the ERW-7 cable which is connected
to the USB port of a PC to allow the use of memory editing software.
Moreover, you can use the ERW-8 to control most functions of the DJ-
X11 in real time, and charge the battery pack. Note that these operations
require additional software. The ERW-8 should be used together with the
EDC-174 charger. The following setting is necessary when you use the
ERW-8.
Remote COM port
Disable
145.000
F M
VFO
B S
1 Rotate the upper dial to select
“Remote COM port”.
2 Rotate the lower dial to select
“Enable” or “Disable”.
MEMO
• It will take about eight hours to fully charge an empty battery pack using
ERW-8.
• When “Enable” is selected, the ERW-7 cannot be used.
• ERW-7 can’t real-time control the DJ-X11.
10-5 Scan Setting
Use this menu to set various scan functions included in the DJ-X11.
145.000
F M
VFO
B S
<
SCANNING
>
1 Select from the
Set mode menu.
2
Press the
SET
CLR
key to display the
sub menu.
10-5-1 Scan mode setting
Use this setting to select the condition to resume scanning.
145.000
F M
VFO
B S
Scan mode
Busy scan
1 Rotate the upper dial to select
“Scan mode”.
The LCD displays the information as
shown on the right.