Alinco DJ-X11 - Manual (Page 89)

10
10. Set Mode Confi gurations
89
2 Rotate the lower dial to select “Busy scan”, “1sec.
timer” to “25sec. timer”, or “1sec. elapse” to “5min.
elapse”.
Refer to the table below to select your desired mode.
Busy scan mode After scanning stops, the DJ-X11 resumes
scanning when there is no signal to receive.
Timer scan mode After scanning stops, the DJ-X11 resumes
scanning after the specifi ed time even though
it is still receiving signals. The timer period can
be set within the range from 1 to 25 seconds
("1sec. timer" to "25sec. timer").
Periodic scan mode When the specified time elapses, the DJ-
X11 automatically moves to the next channel
regardless of the presence of signals. This
is true even while the squelch is open. The
elapsed time can be set within the range of 1
second to 5 minutes ("1sec. elapse" to "5min.
elapse").
MEMO
• The periodic scan is a scan mode to let the DJ-X11 automatically move
to the next channel when the specifi ed time elapses, regardless of the
presence of signals. This is done even while the squelch is open. Con-
sequently, this function is useful when you receive data communication
such as ACARS (Aircraft Communication Addressing and Reporting
System) and want to receive data from multiple channels at specifi c time
intervals or to scan each channel by taking some time for monitoring.
• This function can be used in VFO, Preset, and Memory modes.
10-5-2 Priority Monitoring interval setting
Use this setting to specify the time to monitor the priority channel when
the Priority Monitoring function is ON.
Prio. interval
5sec.
145.000
F M
VFO
B S
1 Rotate the upper dial to select
“Prio. interval”.
The LCD displays the information as
shown on the right.
2 Rotate the lower dial to select
the monitoring period between
the range of 5 to 60 seconds.