Alinco DJ-X11 - Manual (Page 93)

10
10. Set Mode Confi gurations
93
10-7-2 Bell function setting
The Bell function uses a bell sound to provide notifi cation when a signal is
received.
Bell
OFF
145.000
F M
VFO
B S
1 Rotate the upper dial to select
“Bell”.
The LCD displays the information as
shown on the right.
2 Rotate the lower dial to select “OFF”, “Main band only”,
“Sub band only”, or “Either band”.
When the Bell function is enabled, appears on the LCD.
When a signal is received, fl ashes and a bell sounds.
Since continues fl ashing until the next key operation, this function can
also be used as a "signal reception notifi cation" when you leave the DJ-
X11 momentarily.
OFF A bell does not sound.
Main band only
A bell sounds when a signal is received on the
main band.
Sub band only
A bell sounds when a signal is received on the
sub band.
Either band
A bell sounds when a signal is received on
either of the bands.