Alinco DJ-X11 - Manual (Page 38)

38
7. Memory Mode
7
7-3 Calling Up a Memory Channel
1 Press the key to switch to Memory mode.
2 Press the or key to select the memory bank to
call up.
3 Rotate the dial to select the memory channel.
CAUTION
• When you call up the data in the bank for dual band channels, you
cannot switch between the main and sub bands.
• When a frequency which is out of the range of the sub band is pro-
grammed in the memory channel with the main band, that frequency
cannot be displayed with the sub band.
Refer to (P. 33) in “Receiving Operation” for the range of the receivable
frequencies for the sub band.
• This function cannot be used when the memory channel programming
is not valid.
Example: Use the main band to call up 145.000 MHz programmed in
channel 002 of bank 15.
(1) Set the main band as the band to operate and press the key to
switch to Memory mode.
(2) Press the key to select bank “15”.
(3) Rotate the upper main dial and select channel “002”.
The memory channel programmed in the memory is displayed.
7-4 Deleting a Memory Channel
1 Set the “Write-protect (memory protection) function” (P.
91) to “Prohibited” or “fail-safe”.
2 Press the key to switch to Memory mode.
3 Select the memory channel to delete.
4 Press the [FUNC] key to display on the LCD.
Clear → ENT key
Cancel → Other
0 0 2
0 1 5
MR 145.000
F M
B S
5 Press the key, and a con-
fi rmation notice is displayed as
shown on the right.
6 Press the
STEP
key to delete
the channel from the memory.
Pressing another key cancels
the operation.