Alinco DJ-X11 - Manual (Page 91)

10
10. Set Mode Confi gurations
91
10-5-5 Scan speed setting
Use this setting to change the scan speed.
Scan Speed
Slow
145.000
F M
VFO
B S
1 Rotate the upper dial to select
“Scan Speed”.
The LCD displays the information as
shown on the right.
2 Rotate the lower dial to select from three levels: “Slow”,
“Normal”, and “Fast”.
10-6 Memory Setting
Use this menu to set the memory functions.
145.000
F M
VFO
B S
<
MEMORY
>
1 Select from the Set
mode menu.
2
Press the
SET
CLR
key to display the
sub menu.
10-6-1 Write-protect (memory protection) function setting
Use this setting to enable editing (overwriting or deleting) for the channel
data programmed for the Memory mode.
Overwrite
Prohibited
145.000
F M
VFO
B S
1 Rotate the upper dial to select
“Overwrite”.
The LCD displays the information as
shown on the right.
2 Rotate the lower dial to select the write-protect options.
Rotating the dial switches the options as follows:
Accepted Prohibited fail-safe
Accepted Write-protect is enabled. You cannot edit the
data programmed in the memory.
Prohibited Write-protect is disabled. You can edit the data
programmed in the memory.
fail-safe You can edit the data programmed in the
memory. When the receiver is turned off once
and turned on again, write-protect is enabled
automatically.
To delete a memory channel, refer to the procedure shown in “Deleting a
Memory Channel” (P. 38).