Alinco DJ-X11 User Manual
Page 42
42
7. Memory Mode
7
● Entering a memory name
The keys on the key pad are assigned to characters. (P. 43 to P. 47)
When you press the keys on the key pad one at a time, the corresponding
characters are displayed in the order the keys were pressed.
When you press the key on the key pad and then rotate the upper dial,
the characters assigned to the key are displayed in succession. Rotating
the dial further displays kanji characters.
Entry example: To enter "DJ - X11 "
1
Press the
key and rotate the upper dial to select “D”.
2
Press the
key and rotate the upper dial to select “J”.
3
Press the
key and rotate the upper dial to select “-”.
4
Press the
key and rotate the upper dial to select “X”.
5
Press the
WILD
key once and rotate the lower dial to move
the character entry cursor.
D J - X 1 1
15-002
Registered channel name
Memory channel
Bank No.
F M
B S
6
Press the
WILD
key once and ro-
tate the lower dial to move the
character entry cursor.
7
Press the
key and rotate
the dial to select “ ”.
8
Move the cursor to the right by
rotating the lower right dial.
9
Press the [FUNC] key to finish the setting.
MEMO
• Even after the memory name is registered, you can use the frequency
display. Refer to “Memory name display setting” (P. 92).
• You can create your own pictographs using the utility software.
• The flashing character is not yet registered. Be sure to move the cur
-
sor to the right so that it stop flashing.
• It is recommended to use Alinco’s DJ-X11 free utility software down
-
loadable from alinco.com site for easier and faster naming operation.
One of ERW-4C/7/8 optional PC-connection cables is necessary to
operate with the software.