Alinco DJ-X11 - Manual (Page 57)

8
8. Functions Assigned to the Key Pad
57
8-8 Frequency Shift Function
The Frequency Shift function switches from the frequency currently being
received to another frequency with the press of a single key. For example,
communication with a repeater (relay) uses sending (uplink) and receiving
(downlink) frequencies separately. The Frequency Shift function allows you to
receive signals of both frequencies alternately by switching between them with
a press of a key.
8-8-1 Setting the Frequency Shift function
1 Press the [FUNC] key to display on the LCD.
OFF
-
145.000
F M
VFO
B S
Shift
-0.600
2 Press the
SHIFT
key to select the
direction of the frequency shift.
Every time you press the
SHIFT
key, the
display changes in the order shown on
the right.
3 Rotate the dial to set the frequency tuned by the shift.
You can change the frequency in steps of 1MHz by rotating the dial while
holding down the [FUNC] key.
4 Press the [FUNC] key to complete the setting.
MEMO
• Normally, communication via a repeater can be received by tuning to
the downlink frequency (the frequency which the repeater uses tore-
send the received signal).
• When this function is used, the base-station signals are relatively
strong and can be received easily.
• The mobile-station signals, however, are not so strong and can be
heard only within the coverage area.
This function is commonly described a “reverse-monitor” in amateur-
radio equipment.
8-8-2 Using the function
Press the
SHIFT
key to receive the shifted frequency.
Press the SHIFT key again to receive the original frequency.
CAUTION
• To cancel the Frequency Shift function, press the [FUNC] key to display
on the LCD, hold down the SHIFT key until “OFF” appears, and then
press the [FUNC] key again.