Alinco DJ-X11 - Manual (Page 66)

66
9. Useful Functions
9
9-6 Programmed Scan
The Programmed scan searches a range of frequencies specifi ed by upper and
lower limits. The specifi ed upper and lower frequencies are collectively referred
to as a "programmed scan channel". The DJ-X11 can store up to 50 pairs of
programmed scan channels. For more information, refer to "Programming a
Memory Channel" (P. 35). Note that you need to program data in the bank for
programmed scan channels in advance. If you do not do this, the following
operation cannot be performed.
1
Press the key to switch to VFO mode.
145.000
F M
B S
VFO
Prg-Scan 1
2 Hold down the key and
rotate the upper dial to select
“Prg-Scan”.
3 Release the key to start scanning.
During scanning, the decimal point of the displayed frequency fl ashes.
4 Press the [FUNC] or key to stop scanning.
9-7 Tone Scan
The Tone scan automatically detects a tone frequency in the received radio
signals.
1 In VFO mode, tune to the frequency to search for a tone
frequency.
145.000
F M
B S
VFO
TONE scan
2 Hold down the key and
rotate the upper dial to select
“TONE scan”.
3 Release the key to start scanning.
Scanning starts. Tone frequencies being scanned for are displayed on the
LCD one at a time.
When a matching tone is found, a beep sounds, “
” and the tone
frequency are displayed on the LCD, and scanning stops. Scanning
continues when no tone frequency is found in the received radio signals.
4 Press the [FUNC] or key to stop scanning.