Alinco DJ-X11 - Manual (Page 77)

10
10. Set Mode Confi gurations
77
10-1-6 F Tuning function operation setting
Use this setting to specify the frequency range used to scan signals de-
tected by the F Tuning function. When “3” is selected, the scanning range
is set to be wide to allow accurate tuning; however, extra time is required.
Selecting “1” fi nishes scanning faster; however, the receiver may not tune
to the target signal properly. The DJ-X11 provides a variable range be-
cause the required accuracy varies depending on the conditions such as
the strength of the target signal.
145.000
F M
VFO
B S
Tune setting
2
1 Rotate the upper dial to select
“Tune setting”.
2 Rotate the lower dial to select
from “1” through “3”.
10-1-7 IQ signal output function
The DJ-X11 can output IQ signals from the earphone jack. By connecting
the earphone jack and the PC's MIC/LINE IN input port with a commer-
cially-available cable with ø3.5 mm stereo mini-plugs on both ends (the
specifi cation is the same as the cable used for the Cable-clone function
described on P. 98), you can use SDR (Software Defined Radio) pro-
grams to enjoy reception on the PC using software available on the Inter-
net. Since some of these programs offer functions which are unavailable
with the DJ-X11 such as DSP (Digital Signal Processor), this function will
expand the fun of "watching".
CAUTION
• Although Alinco has confi rmed operation by testing several software
programs developed by third-parties, some programs may not be us-
able due to various conditions such as the compatibility of your pro-
gram and PC, PC properties setting, and the signal receiving environ-
ment (noise or suppression). Note that Alinco does not offer any sup-
port other than testing “Weather or not your DJ-X11 meets our factory-
standard specifi cations.” for this reason. Moreover, we cannot answer
questions about the operating procedure of specific software or the
type or environment settings of PCs.