Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 95)

4.3.3. Cables’ Connections
The next step in the installation procedures requires connection of cables to the CommVerter.
NOTE
The connection to the Mains power plug should be done
only after all the communications cables are inserted, and
not previously.
Proceed as follows:
1. Make all necessary communication cables’ connections to the CommVerter , in
accordance with the fuel station configuration and with the special requirements of
the installed cables
NOTE
The CommVerter kit includes only the relevant connectors
as specified in the supported communication conversion
method.
2. Connect the Power Supply cable to the CommVerter
3. Connect the power cable to the Mains (110VAC to 230 VAC).
NOTE
If an adapter to the Mains wall plug is required (in
accordance with the local configuration), please obtain it
beforehand – it is not included in the shipment.
NOTE
The CommVerter kit includes only the relevant connectors
as specified in the supported communication conversion
method.
8 Port CommVerter Operation and Installation Manual 91