Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 124)

FINAL PROCEDURES
Proceed as follows:
 After checking that the correct parameters are displayed, click on “OK” button
 Close the application.
 Connect the CommVerter to switch hub anew
 Turn the CommVerter on
 Run the tfdp32.exe file and open the “tftpd32” application again (see Figure A-3)
 from your laptop, try to ping the CommVerter and confirm the valid communication
link
 Browse the CommVerter > admin task
 “Reset” the CommVerter. Reset also can be done by turning off then on the
CommVerter while the “tfdp32” application is open
 The firmware version is automatically updated within the CommVerter with the
“bsp8p_controler.bin” file (see Figure A-3). The upload process is shown
graphically.
Figure A-3 Application Setting Parameters
8 Port CommVerter Operation and Installation Manual 120