Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 112)

 “Read default”
This option enables reading all the factory defaults from the memory. At this stage you can
introduce all necessary changes and store it in EEPROM.
 “Write to EEPROM”
This option is necessary to transfer and store all the changes and parameters from the RAM
memory to the EEPROM. If you do not use this option after performing any change, the changes
will be lost after the CommVerter setup. However this Save is temporary. You must initialize a
Reset procedure for the change to take effect.
 “Write to EEPROM and Reset”
Use this option to transfer and store all the changes and parameters from the RAM memory to
the EEPROM and perform an automatic Reset procedure afterwards, fully implemented . Once
this procedure is performed successfully, the changes are implemented in the CommVerter.
 “Read default and Write to EEPROM”
Use this option to read all the factory defaults and at the same time write them into the
EEPROM.
 “Clear reset counter”
This option enables setting to zero the counters responsible for counting the system “start ups”.
 “Reset”
Use this option to reset the CommVerter.
8 Port CommVerter Operation and Installation Manual 108