Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 46)

10. Click on Serial Ports. The Serial Ports screen is displayed. Scroll down the page to reach
the Port that needs to be changed (see Figure 2-21)
11. This example refers to Port 205. Actual Port number2xx is determined by the Port assigned
to the Slot of the Current Loop Interface module board
12. Change the port setting as needed. See paragraph 2.3
13. Click on the Send button for the appropriate port
Figure 2-21. CommVerter Unit Setup Site – Serial Ports Screen
14. After changing and sending the Port settings, the eeprom must be updated and reset:
a. Click on Admin Tasks. The Admin screen is displayed
b. Select the Write to eeprom radio button in the Set/Get eeprom section
c. Click on the Send button in this section of the page
d. Select the Reset radio button in the Set/Get eeprom section
e. Click on the Send button in this section of the page
15. Give the system a few minutes to reboot and then verify that the settings have been saved.
8 Port CommVerter Operation and Installation Manual 42