Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 79)

2.16. DOOR OPEN DETECTION
The FFC includes a feature for preventing unauthorized third parties from forcing the sealed FCC
box door.
The FCC generates an alarm in cases where the door was opened.
The function setup procedure comprehends:
a. Physical connection of the detector, as described below
b. Digital I/O jumper setup (described in paragraph 5.7.1)
c. SiteOmat setup (described in SiteOmat Installation and Maintenance Manual, P/N
817423756, paragraph 6.3.1)
2.16.1. Door Open Detector Installation
The detector is composed of two parts:
 A connector including a magnet at the end of the cable
 An additional magnet
The detector should be connected to the 8-Port Commverter and affixed to the FCC cabinet.
Proceed as follows:
1. Connect the detector connector to the I/O Cn6 Jumper (see Figure 2-57 )
2. Attach the additional magnet to the inner side of the FCC door, using the adhesive
tape
3. Attach the detector magnet to the box inner wall in front of the additional magnet,
using the adhesive tape
8 Port CommVerter Operation and Installation Manual 75