Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 44)

8 Port CommVerter Operation and Installation Manual 40
2.7.6. Gilbarco Legacy & Gasboy 8800 Current Loop Electronic Pumps
Configuration
To set up the Gasboy 8800 current loop electronic pumps install the current loop board in the
correct slot of the 8 port CommVerter board.
In the following example Slot 3 of the 8 port CommVerter board is used. The port assigned to
Channel 1 of this Slot is 3005.
N N O O T T E E
The Current Loop Interface module can be installed
in any slot of the 8 port CommVerter board. The slot
used may vary depending on system configuration.
Adjust the instructions according the Slot used for
the Current Loop Interface module board. The Slot
used is mapped to the assigned Port number.
In order for the Current loop board to communicate with the Gasboy 8800 pumps the ports setting
must be changed. Proceed as follows:
1. Connect the CommVerter to a PC (LAN Connection)
2. Open the Web browser, and enter the IP address of the Commverter. The Setup Main Screen
is displayed (see Figure 2-19)
Figure 2-19. CommVerter Unit Setup Site – Main Screen