Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 29)

2.4.2. Mating a Connector
The CommVerter kit includes one size mating connectors to be wired in accordance with the
selected fuel station configuration and consequently, the required conversion method.
To wire a mating connector (see Figure 2-6), proceed as follows:
1. For all modules, use standard 8-pin Phoenix-type male connector (P/N 813325001),
to be connected to the CommVerter.
2. For LAN connection, use RJ45 cat5 LAN cable (not included in the kit).
3. Wire the connector in accordance with its pinout definition as described in the
following paragraphs. The wiring shall be performed in accordance with the
CommVerter configuration.
NOTE
The connector pinout definition (pin number on top, signal
in second row) is provided when facing the connector,
from right to left.
4. The following paragraphs provide the wiring definition of the ports. These wiring
definitions are also shown on the connectors' labels (see Figure 2-4 and Figure 2-6).
Verify compatibility before connection!!!
Figure 2-6. CommVerter – Connector
8 Port CommVerter Operation and Installation Manual 25