Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 107)

5.5. SERIAL PORTS SETUP PROCEDURES
To setup and define the serial ports in the CommVerter, proceed as follows:
1. In the Main screen, press on the Serial Ports selection
2. Define each Serial Port separately.
3. Press Send to store the selected data in the RAM memory. The stored data is
temporary kept.
The new identification data is uploaded only after writing in the EEPROM (see Admin paragraph)
and Reset action.
.
Figure 5-5. Serial Ports Setup Screen
8 Port CommVerter Operation and Installation Manual 103