Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 102)

5
SETUP AND CONFIGURATION
SECTION
5.1. GENERAL
This section provides the setup and configuration procedures to enable the CommVerter to operate
properly in its local environment.
NOTE
The following instructions are provided, taking into
consideration that the setup and configuration software
program is installed in the Station Controller.
The setup and configuration procedures consist of:
 Displaying the Lan CommVerter Main page
 Configuring the Ethernet parameters such as IP & MAC addresses of the
CommVerter
 TCP/IP port addressing
 Changing the parameters for each serial ports such as; baud rate, parity, stop bit
 Performing administrative task
 Monitoring
NOTES
1. The 8-port CommVerter performs an automatic Restart
procedure every 30 seconds (default) whenever it is not
connected to external equipment. You can determine this
timeout value by clicking in the appropriate box. Refer tp
paragraph 5.8.2.
2. The values entered for each type of configuration are
saved separately. For example, changes in UART 1 are
saved separately to changes in UART 2. In any case, the
change will be saved only by writing the new data in the
EEPROM by means of the Admin Task.
8 Port CommVerter Operation and Installation Manual 98