Gasboy FuelOmat system 8 Popt Commverter - Manual (Page 105)

5.3. ETHERNET SETUP PROCEDURES
To setup and define the Ethernet communication on the Ethernet screen, proceed as follows (see
Figure 5-3):
1. In the Main screen, press on the Ethernet selection
2. Insert the relevant data to enable Ethernet communication
3. Press Send to store the selected data in the RAM memory.
NOTE
Before changing the MAC Address, check that the new
address is not in use by any other device in the network. In
any case, the 8-port Commverter is supplied with a unique
MAC Address, which should not be changes unless there
is a local problem. .
The new identification data is uploaded only after writing in the EEPROM (see Admin paragraph)
and Reset action.
NOTE
The MAC Address is stored and kept independently of the
Reset action, that is kept unchanged.
Figure 5-3. Ethernet Setup Screen
8 Port CommVerter Operation and Installation Manual 101