Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 90)

BIOS
ATCA-8330 Installation and Use (6806800S82B) 90
Procedure
To restore the BIOS default settings, proceed as follows:
1. Remove the blade from the system.
See Installing and Removing the Blade on page 53 , for the exact procedure.
2. Set the on-board switch SW4-3 OFF and SW4-4 ON.
See Switch Settings on page 46 , for the exact location of SW4.
3. Install and power up the blade.
See Installing and Removing the Blade on page 53 , for the exact procedure.
4. Wait until the blade has completely booted and is up and running.
5. Remove the blade from the system again.
See Installing and Removing the Blade on page 53 , for the exact procedure.
6. Set switch SW4-3 and SW4-4 to OFF.
Now the BIOS default settings are restored.
4.9 IPMI Support
The ATCA-8330 BIOS provides the following IPMI support:
 Sets initial timestamp for IPMI SEL events
 Sends a Boot Initiated event
 Sends Memory DIMM detect and error events
 Sends RTS detect and error events
 Sends system firmware progress events
 Reads out the IPMC version of the main board and the RTM
 Reads the FRU information of the main board, the Acceleration module and the RTM.
 Logs boot error in case of no boot device found
 Reads the IPMI GUID and fills in the DMI structure 1 UUID.
 Show SEL and Sensor Values in BIOS setup