beautypg.com

17 get payload shutdown time-out command, Table 9-43, Get payload shutdown time-out command description – Artesyn ATCA-8330 Installation and Use (April 2015) User Manual

Page 219: Supported ipmi commands

background image

Supported IPMI Commands

ATCA-8330 Installation and Use (6806800S82B)

219

9.4.17 Get Payload Shutdown Time-Out Command

When the shelf manager commands the IPMC to shut down the payload (that is, sends the
Activate FRU (Deactivate) command), the IPMC notifies the payload by forwarding the
command Activate FRU (Deactivate) to the KCS interface. Provided the OpenIPMI driver has
registered this command for notification, the payload gets notified. Upon receiving this
notification, the payload software is expected to initiate the payload shutdown sequence.
After performing this sequence, the payload should send the Graceful Reset command to
the IPMC over the payload Interface to notify the IPMC that the payload shutdown is complete.

To avoid deadlocks that may occur if the payload software does not respond, the IPMC provides
a special time-out for the payload shutdown sequence. If the payload does not send the
Graceful Reset

command within a definite period of time, the IPMC assumes that the

payload shutdown sequence is finished, and resets the payload.

Table 9-43 Get Payload Shutdown Time-Out Command Description

Type Byte

Data

Field

Request Data

1:3

PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00

Response Data

1

Completion Code

2:4

PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00

5:6

Time-Out measured in hundreds of milliseconds, LSB first