3 artesyn embedded technologies specific commands, Table 9-19, Artesyn oem commands – Artesyn ATCA-8330 Installation and Use (April 2015) User Manual
Page 199: Supported ipmi commands

Supported IPMI Commands
ATCA-8330 Installation and Use (6806800S82B)
199
9.3
Artesyn Embedded Technologies Specific
Commands
The Artesyn Embedded Technologies IPMC supports several commands which are not defined
in the IPMI or PICMG 3.0 specification but are introduced by Artesyn Embedded Technologies:
serial output commands.
Before sending any of these commands, the shelf management software must check
whether the receiving IPMI controller supports Artesyn Embedded Technologies specific
IPMI commands by using the IPMI command 'Get Device ID'. Sending Artesyn Embedded
Technologies specific commands to IPMI controllers which do not support these IPMI
commands will lead to no or undefined results.
Proper handling of these commands is required to write a portable application.
Table 9-19 Artesyn OEM Commands
Command Name
NetFn (Request/Response)
CMD
Description
Set Serial Output
0x2E/0x2F
0x15
Get Serial Output
0x2E/0x2F
0x16
Set Feature
Configuration
0x2E/0x2F
0x1E
Set Feature Configuration Command
Get Feature
Configuration
0x2E/0x2F
0x1F