1 set/get power level, Supported ipmi commands – Artesyn ATCA-8330 Installation and Use (April 2015) User Manual
Page 198
Supported IPMI Commands
ATCA-8330 Installation and Use (6806800S82B)
198
9.2.1
Set/Get Power Level
The blade supports two power levels. In case of a shelf which only allows 200W per slot the P-
States of the blade will be restricted to match this requirement. The second power level has no
restrictions.
For more information, refer to
Get IPMB Link Info
0x2C/0x2D
0x18
-
Set AMC Port State
0x2C/0x2D
0x19
-
Get AMC Port State
0x2C/0x2D
0x1A
-
Get FRU Control Capabilities
0x2C/0x2D
0x1E
-
Get target upgrade capabilities
0x2C/0x2D
0x2E
-
Get component properties
0x2C/0x2D
0x2F
-
Abort firmware upgrade
0x2C/0x2D
0x30
-
Initiate upgrade action
0x2C/0x2D
0x31
-
Upload firmware block
0x2C/0x2D
0x32
-
Finish firmware upload
0x2C/0x2D
0x33
-
Get upgrade status
0x2C/0x2D
0x34
-
Activate firmware
0x2C/0x2D
0x35
-
Query self-test results
0x2C/0x2D
0x36
-
Query rollback status
0x2C/0x2D
0x37
-
Initiate manual rollback
0x2C/0x2D
0x38
-
Table 9-18 Supported PICMG 3.0 Commands (continued)
Command
NetFn
(Request/Response)
CMD
Comments
The firmware upgrade commands supported by the blade are implemented according to
the PICMG HPM.1 Revision 1.0 specification.
The boot block can be updated with PICMG HPM.1 specific commands.