beautypg.com

4 establishing an sol session – Artesyn ATCA-8330 Installation and Use (April 2015) User Manual

Page 179

background image

Serial Over LAN

ATCA-8330 Installation and Use (6806800S82B)

179

RMCP+ Cipher Suites : 1,2,3,3

Cipher Suite Priv Max : Not Available

root@localhost:~#

8.4

Establishing an SOL Session

To start a SOL session, the following requirements must be fulfilled:

An Ethernet LAN connection to the CaveCreek Ethernet controller of the ATCA-8330 must
exist.

ATCA-8330 IPMC firmware must correspond to version 2.00.00000006 and above.

To establish a SOL session

1. Make sure that the requirements detailed above are fulfilled.

2. Compile and install the ipmitool on your target which is destined for opening the

SOL session on the ATCA-8330. For details refer to

Installing the ipmitool

on page

175

.

3. Assign an IP address to the ATCA-8330 SOL interface. For details refer to

Configuring

SOL Parameters

on page 176

.

4. If necessary change user and password.

Default user is "soluser" and password is "solpasswd".

5. Configure the network between the ATCA-8330 and your target, which is destined

for opening the SOL session, so that the SOL IP address is accessible.

6. Start ATCA-8330 SOL session on your target with the ipmitool and the configured

IP address for the ATCA-8330 SOL interface.

MAC Address 00:00:00:00:00:00 means the address is shared between base and SOL
interface. The address can be found out in the MAC address record of the FRU.