Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 48)

Hardware Preparation and Installation
ATCA-8330 Installation and Use (6806800S82B) 48
Table 2-6 Switch SW3 Settings
Switch Function Default
SW3.1 manual “Default SPI Boot Flash” / “Recovery SPI
Boot Flash” select enable.
ON: SW3.2 selects Boot Flash OFF IPMI selects Boot Flash
SW3.2 SW3.2 controls Boot flash select if SW3.1 is ON
OFF = Boot from “Default SPI Boot Flash” device
ON= Boot from “Recovery SPI Boot Flash” device OFF OFF = Boot from “Default
SPI Boot Flash” device
SW3.3 OFF = Faceplate Reset push button enabled
ON = Faceplate Reset push button disabled OFF OFF=Faceplate Reset
push button enabled
SW3.4 OFF = Watchdog trigger enabled
ON = Watchdog trigger disabled (results in cyclic
IPMC Reset), available only in AUTO Power mode
SW100-1 = ON. Not available to customer
powering through IPMC. OFF IPMC Watchdog timer
trigger is disabled (only
for test purposes and
works only in AUTOP-
power mode SW100-1
ON)
Table 2-7 Switch SW4 Settings
Switch Function Default
SW4.1 Reserved OFF Must be OFF
SW4.2 TCO reboot on sec timeout
OFF: enabled
ON disable reboot feature OFF Connected to CCK NRBOOTS
bootstrap pin (no reboot
second try strap)
SW4.3 [SW4.4, SW4.3]
00 - Normal operation
01 - Reserved
10 - Load BIOS Defaults
11 - Port80 to COM1 OFF The Default is 00 - Normal
operation
SW4.4 OFF