Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 17)

ATCA-8330 Installation and Use (6806800S82B) 17
About this Manual
Overview of Contents
This Reference Guide is intended for users qualified in electronics or electrical engineering.
Users must have a working understanding of Peripheral Component Interconnect (PCI),
AdvancedTCA®, and telecommunications.
The manual contains the following chapters and appendices:
 About this Manual on page 17 , lists all conventions and abbreviations used in this manual
and outlines the revision history.
 Safety Notes on page 23 , lists safety notes applicable to the blade.
 Sicherheitshinweise on page 27 , provides the German translation of the safety notes
section.
 Introduction on page 33 , describes the main features of the blade.
 Hardware Preparation and Installation on page 39 , outlines the installation requirements,
hardware accessories, switch settings, installation and removal procedures.
 Controls, Indicators, and Connectors on page 59 , describes external interfaces of the blade.
This includes connectors and LEDs.
 BIOS on page 71 , describes the features and setup of BIOS.
 Functional Description on page 103 , describes the functional blocks of the blade in detail.
This includes a block diagram, description of the main components used and so on.
 Programmable Logic on page 127 , provides information on the maps and registers of the
blade.
 Intelligent Peripheral Management Controller on page 131 , provides information on IPMC of
the blade.
 Serial Over LAN on page 175 , provides information on how to establish a serial-over LAN
session on your blade.
 Supported IPMI Commands on page 181 , lists all supported IPMI commands.
 FRU Information and Sensor Data Records on page 225 , provides information on the blade’s
FRU information and sensor data.
 Replacing the Battery on page 229 , provides the battery exchange procedures.
 Related Documentation on page 233 , provides links to further blade-related
documentation.