beautypg.com

2 ethernet connector, 3 serial interface connector, Figure 3-2 – Artesyn ATCA-8330 Installation and Use (April 2015) User Manual

Page 62: Ethernet interface connectors pinout, Controls, indicators, and connectors

background image

Controls, Indicators, and Connectors

ATCA-8330 Installation and Use (6806800S82B)

62

3.1.3.2

Ethernet Connector

There are two Ethernet connectors:

ETH1 connector P70

The pinout of the connector is as follows.

3.1.3.3

Serial Interface Connector

The blade provides one RS-232 serial interface connector at its faceplate. It is of type RJ-45 and
corresponds to the physical serial interface port 1. By default, the BIOS maps this interface to
the serial interface COM1. The on-board switch 2-1 allows to swap COM1 with COM2, making
COM2 accessible through the faceplate connector instead. Note that the BIOS serial
redirection feature uses COM1 as access interface. Therefore swapping the serial interfaces via
SW2-1 also changes the serial connector that you need to access to make use of the serial
redirection feature.

8

NC

Table 3-2 RJ45 female Serial Line Connector pinout

Pin

Signal

Figure 3-2

Ethernet Interface Connectors Pinout