Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 85)

BIOS
ATCA-8330 Installation and Use (6806800S82B) 85
4.7.3 IPMI
Table 4-10 Advanced --> Super IO Configuration
Item Values Description
UART1 to Front Panel Enable (Default)
Disable This option controls the UART1. When
enabled, ART1 uses address 3F8h and IRQ
4. UART1 is connected to the front panel.
UART2 to RTM Enable (Default)
Disable This option controls the UART2. When
enabled, ART2 uses address 2F8h and IRQ
3. UART2 is connected to the RTM.
Table 4-11 Advanced --> SMBIOS Event Log
Item Values Description
Event Log Enable (Default)
Disable Enable/Disable SMBIOS Event Logging.
View SMBIOS event log -- Press Enter to view the SMBIOS event log
Mark SMBIOS events as
read -- Press Enter to mark all SMBIOS events as
read. Marked events won't be displayed.
Clear SMBIOS events -- Press Enter to clear the SMBIOS event log
Table 4-12 IPMI
Item Values Description
IPMI KCS Interrupt Enable
Disable (Default) Enable/Disable usage of Host Interface
(KCS) interrupt. KCS interrupt is hardwired
to IRQ 6
IPMI Fail Safe Enabled
Disabled
No Change Enable/Disable Fail Safe Policy. Enabled:
IPMC will switch the BIOS boot bank if the
FRB2 watchdog expires.
No Change: Fail Safe Policy will not be
changed by BIOS