4 get feature configuration command, Table 9-23, Feature selector assignment – Artesyn ATCA-8330 Installation and Use (April 2015) User Manual
Page 203: Table 9-24, Get feature configuration command, Supported ipmi commands

Supported IPMI Commands
ATCA-8330 Installation and Use (6806800S82B)
203
The following table provides the feature set supported with ATCA-8330:
9.3.4
Get Feature Configuration Command
This command can be used to get the state of feature configuration during IPMC runtime.
Table 9-23 Feature Selector Assignment
Feature Selector
Description
E0h
FAILSAFE Function Enable/Disable
Table 9-24 Get Feature Configuration Command
Byte
Data Field
Request Data
1
LSB of Artesyn IANA Enterprise Number. A value of CDh shall be used.
2
2nd byte of Artesyn IANA Enterprise Number. A value of 65h shall be used.
3
MSB of Artesyn IANA Enterprise Number. A value of 00h shall be used.
4
Feature Selector, for details see table 3
Response Data
1
Completion Code. Generic plus the following command-specific
completion codes:
80h = feature selector not supported.
2
LSB of Artesyn IANA Enterprise Number. A value of CDh shall be used.
3
2nd byte of Artesyn IANA Enterprise Number. A value of 65h shall be used.
4
MSB of Artesyn IANA Enterprise Number. A value of 00h shall be used.
5
Feature Configuration
00h = disabled (Feature Selector = E0)
01h = enabled (Feature Selector = E0)
02h - C0h = reserved
C1h = enabled and activated (Feature Selector = E0)
C2h - FFh = reserved
6
Persistency / Duration