Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 61)

Controls, Indicators, and Connectors
ATCA-8330 Installation and Use (6806800S82B) 61
3.1.2 Keys
The blade provides one faceplate reset key.
On pressing it, a hard reset is triggered and all attached on-board devices are reset.
3.1.3 Connectors
The blade provides the following connectors at its faceplate:
 1x Ethernet
 1x Serial
 2x USB
3.1.3.1 Serial COM#1 P17
Serial line interface #1 of Glue Logic FPGA is available at the faceplate of ATCA-8330. A female
RJ45 connector is used for serial line connection. Cisco-like pinout according to following table
is used.Additinally, Hardware Handshake support signals are available.
You cannot reset the IPMC via this key.
Table 3-2 RJ45 female Serial Line Connector pinout
Pin Signal
1 NC
2 NC
3 COM1_RS232_TXD
4 GND
5 GND
6 COM1_RS232_RXD
7 NC