Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 52)

Hardware Preparation and Installation
ATCA-8330 Installation and Use (6806800S82B) 52
3. Plug the MO297 SSD module into the MO297 connector. When inserting the
MO297 module to the on-board connector, hold the on-board connector with two
fingers to prevent damage to the connector.
4. Fasten the MO297 SSD module to the blade using the screws that were removed
from the standoffs in the step 2.
5. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 53 .
The additional resource (either memory or SATA SSD) will be detected
automatically during the boot-up sequence.
Removal Procedure
To remove an MO297 SSD module, proceed as follows:
1. Remove the blade from the system as described in Installing and Removing the Blade
on page 53 .
2. Remove the two screws holding the MO297 SSD module .
3. Remove the MO297 SSD module from the blade.
4. Reinstall the blade into the system as described in Installing and Removing the Blade
on page 53 .
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.