Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 86)

BIOS
ATCA-8330 Installation and Use (6806800S82B) 86
4.7.4 Security
Clear Local System
EventLog Enable
Disable (Default) Clear all events in the local system event
log. The value will be reset to [Disabled]
after a reboot.
O/S Watchdog Timer Enable
Disable (Default) If enabled, starts the IPMI watchdog just
before booting the OS. The OS has to shut
off the watchdog timer when successfully
booted.
O/S Watchdog Timer
Timeout 1, 2, 3, 4, 7, 10, 15, 20
minutes
Default: 5 minutes Configure the Timeout of the O/S Boot
Watchdog Timer.
O/S Watchdog Timeout
Action Do Nothing,
Reset (Default),
Power Down, Power Cycle Configure how the system should respond
when the Boot Watchdog expires.
Local SEL -- Press Enter to show the local System Event
Log (SEL)
FRU Information -- Press Enter to show the FRU information of
the board, the Acceleration Module and
the RTM.
Show Board Sensors -- Press Enter to show the state of the boards
voltage and temperature sensors.
Table 4-12 IPMI
Item Values Description
Table 4-13 Security
Item Values Description
Set Supervisor Password -- Press Enter to set or clear the Supervisor
password.
Supervisor Hint String -- Press Enter to type the Supervisor Hint
string.
Min. password length 1…20
1: Default Set the minimum number of characters for
the password.