Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 176)

Serial Over LAN
ATCA-8330 Installation and Use (6806800S82B) 176
To install the ipmitool
1. Download the ipmitool tar file from http://ipmitool.sourceforge.net to your blade.
2. Extract the source code.
prompt>tar -xjvf ipmitool-.tar.bz2
3. Go to the directory where you have extracted the ipmitool.
prompt>cd /ipmitool-
4. Build the ipmitool.
prompt>./configure && make && make install
8.3 Configuring SOL Parameters
You can configure the following SOL parameters.
You can use standard IPMI commands or the ipmitool to modify the parameters.
8.3.1 Using Standard IPMI Commands
This example shows how to setup the SOL configuration parameter with standard IPMI
commands. Ipmicmd is used on the local IPMC and the IP is configured.
Table 8-1 SOL Parameters
Parameter Description
Set LAN Configuration Parameter (IP
address/MAC address) Use this command to set the IP and MAC address.
Set Channel Access (Privilege level) Use this command to set the privilege level.
Set User Name Default value is solusername.
Set User Password Default value is soluserpassword.