Artesyn ATCA-8330 Installation and Use (April 2015) - Manual (Page 47)

Hardware Preparation and Installation
ATCA-8330 Installation and Use (6806800S82B) 47
Table 2-4 Switch SW1 settings
Switch Function Default
SW1.1 Default SPI Boot Flash
Write protection OFF Not Write
Protected
SW1.2 Recovery SPI Boot Flash
Write protection OFF Not Write
Protected
SW1.3 TSOP or Debug-Socket
SPI Boot select
OFF= Boot from TSOP SPI
Flash (either
Default/Recovery)
ON = Boot from Debug
Socket SPI Flash OFF Boot from TSOP
SPI Flash
SW1.4 Reserved. Connected to
FPGA OFF Reserved
Table 2-5 Switch SW2 Settings
Switch Function Default
SW2.1 Serial Line #1 and #2 Routing
OFF FPGA-COM#1 to Faceplate
FPGA-COM#2 to RTM
ON FPGA-COM#1 to RTM
FPGA-COM#2 to Faceplate
OFF/OFF COM#1 and #2 (TTL-level)
routing
OFF: FPGA-COM#1 to
Faceplate and COM#2 to
RTM
SW2.2 SW2.2 IPMC Debug Console Routing
OFF IPMC Debug Console at 3-pin Header
ON IPMC Debug Console at Faceplate instead of
FPGA COM OFF/OFF IPMC Debug Console
(TTL-level) routing
OFF:IPMC Debug Console
at 3-pin Header
SW2.3 FPGA_PROM_SEL
OFF = High => Use default FPGA EEPROM
ON = Low => Use Fail-Safe FPGA EEPROM OFF (1) Use standard download
PROM or redundant
download PROM for FPGA
configuration
SW2.4 Reserved OFF