Artesyn ATCA-7368 Installation and Use (June 2014) - Manual (Page 99)

Serial Over LAN
ATCA-7368 Installation and Use (6806800M12D) 99
Sample Procedure
To set the IP address, proceed as follows:
1. Establish an IPMI connection to the blade.
2. Set LAN Configuration Parameter Set In Progress Lock.
ipmicmd -k "f 0 c 1 5 0 1" smi 0
3. Set LAN Configuration Parameter Set IP (172.16.10.11 on channel 5).
ipmicmd -k "f 0 c 1 5 3 ac 10 0a dd" smi 0
4. Set LAN Configuration Parameter Set In Progress Commit.
ipmicmd -k "f 0 c 1 5 0 2" smi 0
6.3.2 Using ipmitool
The example below shows how to setup a LAN configuration parameter for a potential SOL
session with ipmitool for base 1 (channel 5).
n0s70:~ #
ipmitool lan set 5 ipaddr 172.16.0.221
Setting LAN IP Address to 172.16.0.221
n0s70:~ #
The following example shows how to query the LAN parameters that are currently in use for a
potential SOL session for base 1 (channel 5) and base 2 (channel 6):
root@localhost:~# ipmitool lan print 5
Set in Progress : Set Complete
Auth Type Support :
Auth Type Enable : Callback :
: User :
: Operator :
: Admin :