1 set feature configuration (0x1e), Table 7-20, Set feature configuration command – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Page 122: Supported ipmi commands

Supported IPMI Commands
ATCA-7368 Installation and Use (6806800M12D)
122
7.4.1.1
Set Feature Configuration (0x1E)
This command can be used to set the IPMI feature.
Table 7-20 Set Feature Configuration Command
Byte
Data Field
Request Data
1
LSB of Artesyn IANA Enterprise Number. A value of CDh
shall be used.
2
2nd byte of Artesyn IANA Enterprise Number. A value of
65h shall be used.
3
MSB of Artesyn IANA Enterprise Number. A value of 00h
shall be used.
4
Feature Selector.
For details, please see Table 2-16 Feature Selector
Assignments
5
Feature Configuration
00h = disabled (Feature Selector = E2h)
01h = enabled (Feature Selector = E2h)-Default
02h - FFh = reserved
6
Persistency / Duration
00h = volatile. Actual duration depends on
implementation.
01h - FFh = reserved
Response Data
1
Completion Code. Generic plus the following
command-specific completion codes:
80h = feature selector not supported.
81h = feature configuration not supported
82h = configuration persistency / duration not
supported
2
LSB of Artesyn IANA Enterprise Number. A value of CDh
shall be used.
3
2nd byte of Artesyn IANA Enterprise Number. A value of
65h shall be used.
4
MSB of Artesyn IANA Enterprise Number. A value of 00h
shall be used.