1 requirements, 2 default access parameters, 1 requirements 4.2.2 default access parameters – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Page 69: Table 4-1, Bios key codes for terminal emulation program, Bios

BIOS
ATCA-7368 Installation and Use (6806800M12D)
69
4.2.1
Requirements
For serial console redirection, the following is required:
Terminal or terminal emulation which supports a VT100 or ANSI mode
NULL-modem cable
Terminal emulation programs such as TeraTermPro can be used. In order to use TeraTermPro
using the function keys, the keyboard configuration file of TeraTermPro has to be modified as
follows:
4.2.2
Default Access Parameters
By default, the blade can be accessed using the serial interface COM1. This interface is using a
RJ-45 connector at the blade's Faceplate.
A NULL-Modem cable is available as accessory kit for the blade. It converts the RJ-45 connector
to a standard DSUB connector which can be connected to a remote terminal. The following
communication parameters are used, by default:
Baud rate: 38400
Flow control: None
VT-100
8 data bits
No parity
1 stop bit
Table 4-1 BIOS Key Codes for Terminal Emulation Program
Function Key
Key Code
PF1
59
PF2
60