1 supported boot devices, 2 selecting the boot device, Bios – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Page 72

BIOS
ATCA-7368 Installation and Use (6806800M12D)
72
4.4.1
Supported Boot Devices
The BIOS supports booting from the following devices/sources:
USB Devices (Sticks, onboard embedded USB flash disk, Hard Drives, CD-ROM)
SAS controller on ARTM
Fibre Channel Controller on ARTM
Network (BEV)
AMC SATA & SAS HDD
Onboard embedded SDD
Default boot order:
Attached USB CDROM
Removable dev (if applicable)
Attached USB devices of USB external port
SAS HDD connected to ARTM SAS Controller
Base Ethernet Interface
EFI shell
In case BIOS does not find any ready bootable device, it may loop on the source list until any
boot device becomes ready or watchdog bites.
4.4.2
Selecting The Boot Device
There are two possibilities to determine the device from which BIOS attempts to boot:
By setup to select a permanent order of boot devices
By boot selection menu to select any device for the next boot-up procedure only