Artesyn ATCA-7368 Installation and Use (June 2014) - Manual (Page 74)

BIOS
ATCA-7368 Installation and Use (6806800M12D) 74
The following table summarizes the network boot support status:
4.5 Redirection of I/O
4.5.1 Redirection of the I/O to COM ports (Console Redirection)
Redirection of I/O to a COM port makes it possible to control the ATCA-7368 BIOS in an
embedded environment where no VGA adapter is present and no keyboard is attached. The
following options are configurable via BIOS setup:
 Baudrate
9600 baud, 19200 baud, 38400 baud, and 115200 baud are supported. The default value
is 38400 baud.
 COM1port
Gives the user the possibility to select either of the onboard serial port or to disable the
console redirection.
Possible settings: enabled, disabled.
The default value is enabled. If disabled is selected, no redirection of I/O to a COM port will
be performed. COM1 is fully compliant to industry standard 16550 asynchronous
communication controllers and is integrated in the Glue Logic FPGA.
Table 4-2 Network Boot Support Status
Ethernet Interface PXE Boot Support
Front Panel Network Interface 1 (82576EB - 1) YES
Front Panel Network Interface 2 (82576EB - 2) YES
Base Network Interface 1 (82576EB - 1) YES
Base Network Interface 2 (82576EB - 2) YES
Fabric Network Interface 1 (82599EB - 1) YES
Fabric Network Interface 2 (82599EB - 2) YES
1 x 82576EB, total 2 GbE interfaces on RTM YES