2 get serial output command, Table 7-26, Response data of set serial output command – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Page 125: Get serial output command, Supported ipmi commands

Supported IPMI Commands
ATCA-7368 Installation and Use (6806800M12D)
125
7.4.2.1.2 Response Data
The following table lists the response data applicable to the Set Serial Output command.
7.4.2.2
Get Serial Output Command
The Get Serial Output Command provides a way to determine which serial output source goes
to a particular serial port connector.
4
Serial connector type
0: faceplate connector
1: Backplane connector
All other values are reserved.
Note: Only the faceplate connector is supported. No connector on the RTM available.
5
Serial connector instance number. A sequential number that starts from "0".
6
Serial output selector
0: BIOS
2: IPMC debug console
All other values are reserved.
Table 7-25 Request Data of Set Serial Output Command (continued)
Byte
Data Field
Table 7-26 Response Data of Set Serial Output Command
Byte
Data Field
1
Completion code
2
LSB of Artesyn Embedded Technologies IANA Enterprise number.
3
Second byte of Artesyn Embedded Technologies IANA Enterprise number.
4
MSB of Artesyn Embedded Technologies IANA Enterprise number.
Currently, only BIOS output is supported.