beautypg.com

Table 7-8, Configurable system boot option parameters, Table 7-9 – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual

Page 108: System boot options parameter #96, Supported ipmi commands

background image

Supported IPMI Commands

ATCA-7368 Installation and Use (6806800M12D)

108

The following table lists which boot properties can be configured and the corresponding boot
parameter number.

7.2.7.1.1 System Boot Options Parameter #96

This boot parameter is an Artesyn-specific OEM boot parameter. Its definition is given in the
following table.

Table 7-8 Configurable System Boot Option Parameters

Configurable Boot Property

Corresponding Boot Parameter Number

Selection between default and backup boot flash as device
to boot from
Selection between default and backup EEPROM as device
where the on-board FPGA loads its configuration stream
from

96

POST Type

97

Timeout for graceful shutdown

98

BIOS boot parameters as defined in

Table 7-15 on page

114

100

Table 7-9 System Boot Options Parameter #96

Data Byte

Description

1

Bits 7..1: Reserved
Bit 0: Default/backup boot flash selection
0: Boot from default boot flash
1: Boot from backup boot flash
Note: the newly selected boot flash is connected to the
payload immediately, that means writing to the flash is
possible. Its image is executed after the next power-up or
cold reset of the payload.

The System Boot Options parameter #96 is non-volatile. During blade production, its data is
initialized to 0xFF and its state is set to invalid. Its parameter data remains preserved after IPMC
power cycles and firmware upgrades.

This manual is related to the following products: