Table 7-10, System boot options parameter #97, Supported ipmi commands – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Page 109

Supported IPMI Commands
ATCA-7368 Installation and Use (6806800M12D)
109
7.2.7.1.2 System Boot Options Parameter #97
This boot parameter is an Artesyn-specific OEM parameter. Its definition is given in the
following table.
7.2.7.1.3 System Boot Options Parameter #98
This boot parameter is an Artesyn-specific OEM parameter.
Table 7-10 System Boot Options Parameter #97
Data Byte
Description
1
POST Type
Data 1 - Set Selector. This is the processor ID for which the boot option is to be
set.
2
Data 2 - POST Type Selector. This parameter is used to specify the POST type
that the IPMC will execute.
0x00: Short POST
0x01: Long POST
0x02 to 0xFF: Not used
The System Boot Options parameter #97 is non-volatile. During blade production, its data is
initialized to 0xFF and its state is set to invalid. Its parameter data remains preserved after
IPMC power cycles and firmware upgrades.