Artesyn ATCA-7368 Installation and Use (June 2014) - Manual (Page 123)

Supported IPMI Commands
ATCA-7368 Installation and Use (6806800M12D) 123
7.4.1.2 Get Feature Configuration (0x1F)
This command can be used to retrieve the IPMI feature set being configured.
Table 7-21 Feature Selector Assignments
Feature Selector Description
E2h Boot Firmware Automatic Switchover Function Enable/Disable
Table 7-22 Get Feature Configuration Command
Byte Data Field
Request Data 1 LSB of Artesyn IANA Enterprise Number. A value of CDh
shall be used.
2 2nd byte of Artesyn IANA Enterprise Number. A value of
65h shall be used.
3 MSB of Artesyn IANA Enterprise Number. A value of 00h
shall be used.
4 Feature Selector, for details see Table 7-23 on page
124 .
Response Data 1 Completion Code. Generic plus the following
command-specific completion codes:
80h = feature selector not supported.
2 LSB of Artesyn IANA Enterprise Number. A value of CDh
shall be used.
3 2nd byte of Artesyn IANA Enterprise Number. A value of
65h shall be used.
4 MSB of Artesyn IANA Enterprise Number. A value of 00h
shall be used.
5 Feature Configuration
6 Persistency / Duration