beautypg.com

Artesyn ATCA-7368 Installation and Use (June 2014) User Manual

Page 50

background image

Hardware Preparation and Installation

ATCA-7368 Installation and Use (6806800M12D)

50

Installation Procedure

To install a PMEM/SATA module, proceed as follows:

1. Remove the blade from the system as described in

Installing and Removing the Blade

on page 52

.

2. Plug the PMEM/SATA module on the blade so that the module's standoffs fit in the

blade's mounting holes.

3. Fasten the

PMEM/SATA module

to the blade using the two screws that previously had

fixed the S/F memory module to the blade.

4. Reinstall the blade into the system as described in

Installing and Removing the Blade

on page 52

.

The additional resource (either memory or SATA SSD) will be detected
automatically during the boot-up sequence.

Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.

This manual is related to the following products: